Where do I put my nut? 🙂
How's that for a title.
I needed to access the heatsink and heater block, so I removed the fans and removed the front cover from around the heatsink. When I removed that front cover a square nut fell out and for the life of me I can't figure out where it goes. Every slot that I can see already has a square nut in it.
I haven't been able to find a good guide to show where all these nuts are supposed to go.
Any help much appreciated.
Best Answer by karl-herbert:
How's that for a title.
I needed to access the heatsink and heater block, so I removed the fans and removed the front cover from around the heatsink. When I removed that front cover a square nut fell out and for the life of me I can't figure out where it goes. Every slot that I can see already has a square nut in it.
I haven't been able to find a good guide to show where all these nuts are supposed to go.
Any help much appreciated.
Original Prusa manual:
MK3S:
https://manual.prusa3d.com/Guide/5.+E-axis+assembly/1055?lang=en
RE: Where do I put my nut? 🙂
How's that for a title.
I needed to access the heatsink and heater block, so I removed the fans and removed the front cover from around the heatsink. When I removed that front cover a square nut fell out and for the life of me I can't figure out where it goes. Every slot that I can see already has a square nut in it.
I haven't been able to find a good guide to show where all these nuts are supposed to go.
Any help much appreciated.
Original Prusa manual:
MK3S:
https://manual.prusa3d.com/Guide/5.+E-axis+assembly/1055?lang=en
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Where do I put my nut? 🙂
Ah thanks. I didn't know that it was called the "E-axis assembly" so I passed over that tutorial.