Notifications
Clear all
Napsal : 05/07/2022 7:51 pm
RE: Uneven extrusion after troubleshooting
This does not appear to be close enough to the bed. Your Z is too high. It should be "squished" not round.
Napsal : 05/07/2022 7:57 pm
Topic starter
answered:
RE: Uneven extrusion after troubleshooting
Thanks for your reply. It feels like I'm going through the complete Z adjust range on this. Is there anything else it could be or a way tot find out what the typical z should be on specific filaments?
Napsal : 06/07/2022 6:37 pm
RE:
Check the Lab logbook - who used the printer last? Ask them what settings they changed - might they have knocked the PINDA out of position?
The first layer Z calibration is way too high, it needs more squish ... but your technician should be on top of this..?
There is no fixed Z value, it changes slowly as the nozzle wears in use.
Cheerio,
Napsal : 07/07/2022 1:02 am