strange first layer problem Mk3 2.5

Dernier message

RSS

Jim

(@jim-12)

Active Member

strange first layer problem Mk3 2.5

Hi,

I am trying to get a Mk3 2.5 printer tuned up at my grandchild's school. I have followed the instructions in the manual and tightened and used the calibration tools. Everything came back good. I then ran the first layer calibration and that looked good. Then I ran a 3 X 3 calibration file and got a strange pattern i could not get rid of.

I currently have a Prusa i3 MK3s and never have seen this problem

Any Ideas would be helpful.

Thanks,

Jim

first layer problem

Publié : 08/10/2022 9:09 pm

Statistiques du forum

559 Forums

62.1 K Sujets

439 K Messages

16 En-ligne

67.2 K Membres

Le dernier des messages: PrusaSlicer 2.8.1 regression in ruler scroll wheel behaviour (1 mm vs. 1 layer) Notre nouveau membre: Gajowy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé