Strange banding artifact in print
Hi all,
I finished assembling my mk3 a few days ago and have started some test printing but I am getting a strange blobbing/banding artifact randomly. Please see pictures.
Does anyone know what could be causing this? The print is in ultrafine detail Slic3r, hatchbox pla.
Thanks!
Re: Strange banding artifact in print
Read up on extruder linearity correction calibration.
Re: Strange banding artifact in print
Maybe a zipper line. Your start point is the same on each layer and little bit of ooze is deposited there. Maybe try random start points on each layer?
Neal
Re: Strange banding artifact in print
OP really needs to elaborate on what the specific issue being addressed. I originally thought it was a concern about the moire-type patterning, but now can see it might be that rough layer near the top (at right in pics).
Re: Strange banding artifact in print
Hey ya gave a place to look and chances are he'll need that link later. Myself...I'm still fighting my "get a bigger hammer" instincts.
Neal.
Re: Strange banding artifact in print
Myself...I'm still fighting my "get a bigger hammer" instincts.
Hammer-schmammer, what do they teach you kids these days?
All you need is a roll of duct tape and a can of WD-40. 
That's "MISTER Old Fart" to you!
Re: Strange banding artifact in print
[quoteHammer-schmammer, what do they teach you kids these days?
All you need is a roll of duct tape and a can of WD-40. ][/quote]
Shows what you know. Duct tape and WD-40 are for AFTER the hammer.
Neal
P.S. I still drop a bit of Marvel's Mystery Oil in my carburetor to keep my engine de-gunked and a drop of lemon juice in the battery if its acting a little sluggish.
Re: Strange banding artifact in print
Shows what you know. Duct tape and WD-40 are for AFTER the hammer.
Not if you're doing it right. 😉
That's "MISTER Old Fart" to you!