Notifications
Clear all
Settings for filaments
Hey everybody.
We just bought those two filaments from the prusa-shop:
PLA Extrafill Light Ivory 750g and PLA Extrafill Traffic Black 750g
We are using the Prusa Slicer (newest version) for slicing, but unfortunately we were not able to find a template for the filaments (I think, they are made by Filamentum). Do you have any advice wich settings we should use?
Thanks for your aid and best regards!
Sabine & Bernd
Napsal : 31/05/2019 9:01 pm
RE: Settings for filaments
Start with the "Generic PLA" profile. It'll work just fine.
Napsal : 31/05/2019 9:27 pm
Schehlein se líbí
RE: Settings for filaments
As above and always check temps on the box.
Napsal : 01/06/2019 4:57 pm