Notifications
Clear all
Self Test Fail - Y-Axis
Hey everyone,
I've read all the other self test y-axis failure topics and have tried the following but to no avail. I'd like to check if the community has any ideas for me.
What I've tried so far:
- Various stages of loosening/tightening of the U-bolts
- A few belt tightness levels
- With/without heatbed
- Ensure zipties aren't in the way
- Adjust motor pulley alignment
- Check move axis (goes from 0 to 175 - should this go all the way to 210 - if so does that indicate wrong gear?)
Any help is appreciated, thanks!
https://forum.prusa3d.com/wp-content/uploads/2020/03/VID_20200310_132618.mp4
Ce sujet a été modifié il y a 5 years 2 fois par Balki
Publié : 10/03/2020 1:24 pm
RE: Self Test Fail - Y-Axis
Hi,
Any luck with this? I'm getting the same error message. Have been printing for 200+ hours without a problem but now I'm suddenly stuck.
Any help is appriciated!
Publié : 26/03/2020 7:23 pm