Notifications
Clear all

Ripping first layer?  

  RSS
Alpha
(@alpha)
Estimable Member
Ripping first layer?

Having a weird first layer issue where the filament is peeling away in 'waves' after a certain amount of printing?

Any ideas what I should check? Tried cleaning, acetone, other side of sheet, z-level, first layer calibration etc

Posted : 15/01/2019 10:31 pm
MikiCab
(@mikicab)
Reputable Member
Re: Ripping first layer?

i would say your first layer is too high.
Here is the best video I have found. I think you need to mush it a bit more into the plate.

Posted : 16/01/2019 4:43 am
Share: