Benachrichtigungen
Alles löschen
Ripping first layer?
Having a weird first layer issue where the filament is peeling away in 'waves' after a certain amount of printing?
Any ideas what I should check? Tried cleaning, acetone, other side of sheet, z-level, first layer calibration etc
Veröffentlicht : 15/01/2019 10:31 pm
Re: Ripping first layer?
i would say your first layer is too high.
Here is the best video I have found. I think you need to mush it a bit more into the plate.
Veröffentlicht : 16/01/2019 4:43 am