Notifications
Clear all

Printer fails bed leveling  

  RSS
Sam
 Sam
(@sam-19)
Membre
Printer fails bed leveling
Publié : 30/07/2024 4:49 am
Robin
(@robin)
Noble Member
RE:

Difficult to see on your video, but it looks like the extruder is turning a bit around the x-axis while sensing. That could indicate the nozzle hitting the bed which should not be the case. Check the correct mounting of PINDA vs nozzle. https://help.prusa3d.com/guide/how-to-replace-a-p-i-n-d-a-sensor-mk3s_163386  

Ce message a été modifié il y a 2 months 2 fois par Robin

If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!

Publié : 01/08/2024 9:19 am
Ray Hodson
(@ray-hodson)
Membre
RE: Printer fails bed leveling

Publié : 22/08/2024 6:26 am
Partager :