Notifications
Clear all
Print problems
Hey everyone. I assembled Prusa MK3S few days ago and i'm struggling with print problems. I did recheck XYZ axis, tighten screws and srtech belts but problems stays... Its look like printer sometimes goes to high and there are gaps in layers.
I attach some photos and short clip, on 7-8 sec you can hear a cracking sound this is moment when printer shift up (i think) too much. Movie was recoreded while printing stick from 3rd picture.
Any ideas where is problem?
Ce sujet a été modifié il y a 6 years par Bogas
Publié : 17/05/2019 8:07 pm
Topic starter
answered:
RE: Print problems
After few days of struggle i finaly fix a problem. I use support chat and conclusion was that part that is causing problem is trapezoidal nuts. I swich places of that nuts and i swich places for smooth rods as well, after that printer is working perfectly.
Publié : 26/05/2019 8:44 am