Benachrichtigungen
Alles löschen
Print problems
Hey everyone. I assembled Prusa MK3S few days ago and i'm struggling with print problems. I did recheck XYZ axis, tighten screws and srtech belts but problems stays... Its look like printer sometimes goes to high and there are gaps in layers.
I attach some photos and short clip, on 7-8 sec you can hear a cracking sound this is moment when printer shift up (i think) too much. Movie was recoreded while printing stick from 3rd picture.
Any ideas where is problem?
Dieses Thema wurde geändert Vor 5 years von Bogas
Veröffentlicht : 17/05/2019 8:07 pm
Themenstarter answered:
RE: Print problems
After few days of struggle i finaly fix a problem. I use support chat and conclusion was that part that is causing problem is trapezoidal nuts. I swich places of that nuts and i swich places for smooth rods as well, after that printer is working perfectly.
Veröffentlicht : 26/05/2019 8:44 am