Notifications
Clear all
Orange PLA Will Not Stick to Bed
After assembling my MK3 printer I couldn't get the Prusa orange PLA (that I order as an extra roll of PLA with the printer) to stick to the bed. I switch to the silver PLA that comes standard with the printer and it sticks fine. Is there different settings for different colors or did I get a bad roll of orange PLA?
Publié : 03/11/2022 6:57 pm
RE: Orange PLA Will Not Stick to Bed
No, that should make no difference. Are you sure you got PLA? Double check the label on the spool...
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Publié : 05/11/2022 12:17 pm