Avisos
Vaciar todo
One calibration point is bad
which causes this, the calibration point marked with a circle. All other points are good except that one. How can that be fixed to get a good first layer.
Este debate ha sido modificado el hace 3 years por Pas0li
Respondido : 10/02/2022 5:42 pm
RE: One calibration point is bad
Looks like poor adhesion, may be some contamination on the sheet.
Regards
-Bob
Prusa I3 Mk2 kit upgraded to Mk2.5s, Ender3 with many mods, Prusa Mini kit with Bondtech heat break, Prusa I3 Mk3s+ kit
Respondido : 11/02/2022 3:39 pm