Notifiche
Cancella tutti
Nozzle touch print
my nozzle touches the infill on the video that can be heard around 15 seconds. You hear a little bit of rattling. usually this is much worse what will be the problem?
Things that are good:
The first layer is really perfect and smooth
XYZ calibration is good.
Postato : 03/05/2018 6:31 pm
Re: Nozzle touch print
somewhat normal depending on the print and what type/density of infill used. There was a thread about it with a response from prusa a while back but I can't find it.
Postato : 06/05/2018 6:42 am
Topic starter
answered:
Re: Nozzle touch print
I have made a movie that you hear that beeps. I think it's really a hardware problem.
Here some photo's of the infill:
I have already replaced the nozzle
recalibrated.
reassembled the printer
Postato : 06/05/2018 10:04 am
Topic starter
answered:
Re: Nozzle touch print
And another problem.... printers stops randomly and starts agian:
Postato : 06/05/2018 1:03 pm