Notifications
Clear all
New here and printed the first item. Overal satisfied but the first layer is not ok
Hi
I choose of course Buddy but in the beginning it went wrong. The rest looks very good. What happened and is it possible to look into the GCode 
Napsal : 28/03/2021 11:22 am
RE: New here and printed the first item. Overal satisfied but the first layer is not ok
Welcome. Common issue for new people. Covered probably a trillion times in these forums. You need to get Live Z right. Check this out: https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Napsal : 28/03/2021 12:18 pm
FRANK se líbí
RE: New here and printed the first item. Overal satisfied but the first layer is not ok
Yip, looks a bit off to me as well.
Make sure the bed is spotlessly clean as well.
And be sure to enable 7x7 bed levelling.
Tank you very much!
Napsal : 29/03/2021 10:00 pm