Notifications
Clear all

MK3S Parts Settings  

  RSS
JMcK
 JMcK
(@jmck)
Reputable Member
MK3S Parts Settings

So I'm about ready to print the parts for the MK3S. Recommended settings are 0.20mm and Grid infill.

Other than taking longer to print, is there a downside to printing finer? I generally like my results with 0.10mm.

I also like gyroid infill better than grid. Any issues there?

When someone asks you if you're a god, you say, "YES!"

Opublikowany : 25/03/2019 4:17 am
Olef
 Olef
(@olef)
Prominent Member
Re: MK3S Parts Settings

I printed two lots at 0.15, both are working fine. I see no reason why your settings wouldn't be OK. Be sloooow though...

Opublikowany : 25/03/2019 7:47 am
wieman01
(@wieman01)
Estimable Member
Re: MK3S Parts Settings

Finer prints will do, don't worry about it.

3D Druck für Einsteiger leicht gemacht: www.3d-druck-lernen.de

Opublikowany : 25/03/2019 10:41 am
JMcK
 JMcK
(@jmck)
Reputable Member
Topic starter answered:
Re: MK3S Parts Settings


Be sloooow though...

I split the parts into 3 batches. ~20 hours total time. Don’t know when I’ll get to assembly, I haven’t even ordered the kit yet. So a month at least.
I’ll probably be printing a bunch of “before’ prints.

When someone asks you if you're a god, you say, "YES!"

Opublikowany : 26/03/2019 11:29 am
Share: