Notifications
Clear all

Mesh bed leveling  

  RSS
josescxavier
(@josescxavier)
Active Member
Mesh bed leveling

Hi,

The printer does the mesh bed leveling every time it prints. Is it normal that the nozzle touch the plate on the calibration points?

 

Thank you

Publié : 25/09/2019 10:56 am
RH_Dreambox
(@rh_dreambox)
Prominent Member
RE: Mesh bed leveling

Absolutely not!

The nozzle must never sit so low that it hits the plate.
You need to adjust the Z level = lower PINDA 0.5 - 1 mm.

Bear MK3 with Bondtech extruder

Publié : 25/09/2019 2:57 pm
josescxavier
(@josescxavier)
Active Member
Topic starter answered:
RE: Mesh bed leveling

@rhdreambox

https://photos.app.goo.gl/8wWpkPVgdj3VtL578

The printed part looks ok and the first layer too.

It is a assembled printer.

Publié : 25/09/2019 3:30 pm
--
 --
(@)
Illustrious Member
RE: Mesh bed leveling

The nozzle isn't touching the bed in that video ...and the mesh level looks normal. And yes, it runs before every print.

Ce message a été modifié il y a 5 years 2 fois par --
Publié : 25/09/2019 5:59 pm
Partager :