Notifications
Clear all
Mesh bed leveling
Hi,
The printer does the mesh bed leveling every time it prints. Is it normal that the nozzle touch the plate on the calibration points?
Thank you
Posted : 25/09/2019 10:56 am
RE: Mesh bed leveling
Absolutely not!
The nozzle must never sit so low that it hits the plate.
You need to adjust the Z level = lower PINDA 0.5 - 1 mm.
Bear MK3 with Bondtech extruder
Posted : 25/09/2019 2:57 pm
Topic starter
answered:
RE: Mesh bed leveling
@rhdreambox
https://photos.app.goo.gl/8wWpkPVgdj3VtL578
The printed part looks ok and the first layer too.
It is a assembled printer.
Posted : 25/09/2019 3:30 pm
RE: Mesh bed leveling
The nozzle isn't touching the bed in that video ...and the mesh level looks normal. And yes, it runs before every print.
This post was modified 5 years ago 2 times by --
Posted : 25/09/2019 5:59 pm