Notifications
Clear all

Help! First Layer Issues  

  RSS
zhodg
(@zhodg)
New Member
Help! First Layer Issues

Hello,

I am new to 3d printing. I got my i3 MK3 a few weeks ago and have about 2 days of run time so far.

I am having issues with this part. I'm not sure what to call it. It appears that the first layer wont stick to the print bed? I used Prusa Control and am using Prusament PETG and haven't worked out the Slicer PE settings yet.

I tried with the print bed clean with 99.9% Isopropyl Alcohol and also with the glue stick provided.

The printer is in my garage so about 65F ambient temp, also I haven't cleaned the print bed with Acetone yet, but ordered it so it's on the way.

I built the Ikea enclosure, but I really didn't like the design of the spool on top so will be rebuilding a new one with the stock spool holder still on the machine.

I attached a photo of an example of whats happening

Appreciate the help and advise

Napsal : 25/01/2019 1:02 am
JoanTabb
(@joantabb)
Veteran Member Moderator
Re: Help! First Layer Issues

Hi Zach,

looks like your first layer is uneven

did you use Prusa first layer adjustment?

it's not very easy to use...
I adjust my live Z using two files,

see Jeff Jordan's thread 'life adjust my way' https://shop.prusa3d.com/forum/assembly-and-first-prints-troubleshooting-f62/life-adjust-z-my-way-t2981.html#p124514

the file, 'S3D_calibration_surfaces_75x75@200um_v6.1.zip' is at the bottom of the first post

this adjusts the middle of the bed, then to adjust the edges of the bed I use a 200 mm square hollow square with concentric infill.... have a look at the following thread,

https://shop.prusa3d.com/forum/general-discussion-announcements-and-releases-f69/mk3-first-layer-help-t27316.html

the 200mm square pla file is at the bottom of my post, there

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Napsal : 25/01/2019 1:33 am
Share: