Español
Foros
English forum
Original Prusa i3 MK3 & MK3S & MK3S+
Assembly and first prints troubleshooting
Heat bed alignment
 
Avisos
Vaciar todo

Heat bed alignment  

    Último Mensaje
  RSS
Nateclaf
 Nateclaf
(@nateclaf)
New Member
Heat bed alignment

Whenever I line up the middle screw when installing my heatbed the other screws do not align. However without the middle screw the rest line up perfectly. And suggestions?

Este debate ha sido modificado el hace 2 years por Nateclaf
Respondido : 23/06/2022 3:50 am
JoanTabb
 JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Heat bed alignment

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Respondido : 23/06/2022 4:29 pm
Nateclaf
 Nateclaf
(@nateclaf)
New Member
Topic starter answered:
RE: Heat bed alignment

Yes it was. The problem was fixed by screwing in the other 8 screws and then doing the middle one. I must have been doing something wrong but it is all set now. Thank you!

Respondido : 24/06/2022 1:34 am
JoanTabb
 JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Heat bed alignment

Good News

Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Respondido : 24/06/2022 2:53 pm
  Todos los debates del foro
  Anterior debate
Siguiente debate  
Debates relacionados
Etiquetas del debate:  Heatbed (93), kit (30), mk3s+ (251), assembly (65),
Compartir: