Notifications
Clear all
hard time printing this tape dispenser core
would print about 1/16" thick of the core and get loose not sticking to bed. i used adhesive, still no luck. any suggestions i can try to complete this print? 
Napsal : 28/05/2023 12:40 am
Rotate the largest flat surface to the print sheet and enable supports.
If problems persist save your project as a .3mf file
Files > Save Project as
Zip the .3mf and post it here. It will contain both your part and your settings for us to diagnose.
Cheerio,
Napsal : 28/05/2023 2:32 pm