Flow set to 95 as standard?

Dernier message

RSS

MileHigh3Der

(@milehigh3der)

Honorable Member

Flow set to 95 as standard?

When I have my Mk3S/MMU running and I look at the 'Tune' settings, the Flow = 95? I didn't see this as an option in the Prusa Slicer? If anything, I find underextrusion more an issue than over. Where can I set this to 100-101?

Publié : 02/12/2019 6:31 pm

Neophyl

(@neophyl)

Illustrious Member

RE: Flow set to 95 as standard?

Its located in the custom gcode section - Printer Settings > Start gcode I think.

Publié : 02/12/2019 7:25 pm

Statistiques du forum

559 Forums

63 K Sujets

443.3 K Messages

24 En-ligne

67.9 K Membres

Le dernier des messages: Whose upgrading to Core One? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé