Notifications
Clear all
Flow set to 95 as standard?
When I have my Mk3S/MMU running and I look at the 'Tune' settings, the Flow = 95? I didn't see this as an option in the Prusa Slicer? If anything, I find underextrusion more an issue than over. Where can I set this to 100-101?
Napsal : 02/12/2019 6:31 pm
RE: Flow set to 95 as standard?
Its located in the custom gcode section - Printer Settings > Start gcode I think.
Napsal : 02/12/2019 7:25 pm