Avisos
Vaciar todo
Fixed clicking, then load filament OVERextrusion
Hi folks,
My MK3 has several times now made a clicking sound mid-print, which I fixed (align gears, clean hotend, cold pull). But then when I load the filament, it loads and suddenly extrudes fast spewing lots of filament, then back to slowly again. It keeps going until I shut it off; it does not ask me if the filament is loaded and extruding the proper color. This fast filament spewing has happened to me a couple of times now. Has anyone seen this or have any ideas?
Upgrading firmware, turning on/off filament sensor, and cleaning the hotend did not solve it.
Any ideas?
Respondido : 12/11/2018 4:44 pm
Re: Fixed clicking, then load filament OVERextrusion
Try a factory reset
Respondido : 12/11/2018 9:54 pm