Notifications
Clear all

[Solved] First turn-on - LCD Wont move off Language selection  

  RSS
Redstick
(@redstick)
Active Member
First turn-on - LCD Wont move off Language selection

Not sure where I went wrong.:(
Assembled the printer over 3 nights. Turned it on and LCD shows the language selection, then goes to "Original Prusa i3 Prusa Research" screen, then lands back on the language selection.

Any ideas on where I went wrong, or what is amiss? What can I do to move forward?

Posted : 26/11/2020 4:04 am
Redstick
(@redstick)
Active Member
Topic starter answered:
RE: First turn-on - LCD Wont move off Language selection

ID10T error here. I was using the "+" as the select 🤪 

Posted : 26/11/2020 4:34 am
vintagepc
(@vintagepc)
RE: First turn-on - LCD Wont move off Language selection

I say this every time... you aren't the first, you won't be the last 😉

 

Posted : 26/11/2020 3:46 pm
Share: