First prints taking ~40% longer than expected

Dernier message

RSS

Peter

(@peter-19)

New Member

First prints taking ~40% longer than expected

Just curious if expectations are correct (gcode files have overall print time in the name). Printed the 3D Hubs Marvin which should take about 50 minutes but took 1hr 10min. Printing the whistle now and am 25 minutes in and it's reporting about 62% complete. Is this way off? Any suggestions?

Publié : 12/05/2018 8:56 pm

Olef

(@olef)

Prominent Member

Re: First prints taking ~40% longer than expected

Ignore those time estimates. they vary between fairly close and hopelessly optimistic. They are just an indication. If you want a far more accurate one re-slice the STL in the Slic3r PE Edition - it gives a very good estimate when saving out the gcode.

Publié : 12/05/2018 11:35 pm

Statistiques du forum

559 Forums

63 K Sujets

443.6 K Messages

20 En-ligne

67.9 K Membres

Le dernier des messages: Is there any way to force support material to only be one filament, but still retain a wipe tower? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé