Notifications
Clear all
First layer problems
The layer lines aren't touching the wall, I also don't know is my z is set too high.
Napsal : 08/04/2020 6:30 pm
RE: First layer problems
It’s hard to tell with that translucent filament. When you peel it off do the lines separate when you try to pull them apart ? If so then it should go lower, it should be a sheet of plastic when removed.
Napsal : 08/04/2020 7:06 pm
RE: First layer problems
Search in the forum for the movie someone made, with very good zoom in, and good and bad settings.
Napsal : 08/04/2020 7:18 pm
Topic starter
answered:
RE: First layer problems
@neophyl
Yes, the layer lines do separate when pulled.
Napsal : 08/04/2020 7:29 pm
Topic starter
answered:
RE: First layer problems
Search in the forum for the movie someone made, with very good zoom in, and good and bad settings.
Do you have the link to it? I cant find it in this fourm.
Napsal : 08/04/2020 7:31 pm
RE: First layer problems
Movie,
http://projects.ttlexceeded.com/3dprinting_bed_adhesion.html
http://projects.ttlexceeded.com/3dprinting_bed_cleaning.html
Napsal : 08/04/2020 10:13 pm