Notifications
Clear all
First layer print with intermittent gap.
I have been trying to test print a cuboid but during the first layer print there is always gap intermittently. I had increased the z level but doesn't help. I had increased the flow from 95 to 98 but doesn't help. Any suggestion from guru?
Napsal : 24/09/2024 4:27 am
Please do a cold pull then run the built-in first layer 'Z' calibration and show us the result *on the print sheet*
https://help.prusa3d.com/article/cold-pull-mk3-s-mk2-5-s-mk3-5-s_2075
Cheerio,
Napsal : 24/09/2024 11:23 am