Notifiche
Cancella tutti

First layer PETG not sticking to print bed  

Pagina 2 / 2
  RSS
AnnieR
(@annier)
Reputable Member
RE: First layer PETG not sticking to print bed

It might sound stupid but hairspray really helps. 

Postato : 05/03/2023 7:11 pm
cwbullet
(@cwbullet)
Utenti
RE: First layer PETG not sticking to print bed

No doubt about it.  

Posted by: @annier

It might sound stupid but hairspray really helps. 

 

--------------------
Chuck H
3D Printer Review Blog

Postato : 05/03/2023 8:25 pm
jsw
 jsw
(@jsw)
Famed Member
RE: First layer PETG not sticking to print bed

It's pretty much been confirmed that some (many? most?) of the 3d print stick-um products are either repackaged hair spray or of a very similar formula.

The hairstylist that my wife and I both use took a look-feel of Layerneer and said it is quite possibly a so-called unscented hair spray and gave the brand name of 'Rave' as one possibility.

I like Layerneer as it works very well and a bottle lasts a very long time with my rate of usage, so I will most likely continue to use it instead of trying to save a few bucks.

Posted by: @cwbullet

No doubt about it.  

Posted by: @annier

It might sound stupid but hairspray really helps. 

 

 

Postato : 06/03/2023 12:34 am
gilesjuk
(@gilesjuk)
Eminent Member
RE: First layer PETG not sticking to print bed

I tried two different reels of PETG (both by the same brand, eSUN), very poor results. But got a reel of ERYONE today and it's amazing in comparison. What I found was the other brand just wouldn't stick well so I was unable to calibrate the Z amount properly, I couldn't tell if the nozzle was too close or too far away. The new stuff is amazing and it shows in the print, the first layer is flawless.

Postato : 08/03/2023 9:17 pm
ogmios
(@ogmios)
New Member
RE: First layer PETG not sticking to print bed

Just wanted to reinforce that the soap and water does the trick, should someone hesitate. 

Postato : 14/05/2024 10:50 pm
Pagina 2 / 2
Condividi: