First Layer Issues - Not Sticking for new slices
I purchased a MK3 a few months ago now. I have been printing the crap out of the loaded test prints (15 Benchys, 40 buddies, a couple Adlindas, a couple Nefertitis and a few dozed geared bearings) but now I have time to figure out how to print my other G-code sliced models but I can not seem to get it to work.
Like I said its calibrated and the Prinda seems to be working fine as the test prints all stick well. I am having issues getting other models to print. I have sliced with both Slic3r 1.3 and Cura 3.5 and 3.6 but when initiating a print the first layer doesn't seem to stick (or stick well) and eventually the print pops off. some time right away and sometimes 10 or so layers in. I have seen people discuss that they have had issues with the Prinda being too high or the nozzle being plugged but wouldn't those also affect the test prints?
I have three other printers (home built and modified Anet A8s) which are sliced with a generic Anet A8 cloned profile. Those slices don't work either.
Any help would be appreciated as I love the quality, speed and lack of noise from the MK3, but if all I can print is the test prints it will be going back.
LFG
Re: First Layer Issues - Not Sticking for new slices
It isn't a PINDA issue.
It is probably one of two things: bed is contaminated or the First Layer cal is a bit high.
Send a photo of one of the parts that popped off, especially the bottom that was in contact with the bed.