Avisos
Vaciar todo
First layer irregularities
Hi! I have been printing a while with my MK3 but lately I’ve been experience some problems. First of all the Z-height seems to vary depending on how far on the Y-axis the print is. Secondly I get artifacts that stick up from the first layer. I have tried to recalibrate the printer but to no success. This problem is also consistent between both PLA and NextGen filament.
Do anyone have any ideas on what to do?
Respondido : 15/07/2018 1:44 pm
Re: First layer irregularities
Were you previously printing part all over the bed like now with success?
If yes, I would say that you may have a partial nozzle clog. Try to change it.
Respondido : 15/07/2018 1:50 pm