Notifications
Clear all

First Layer Calibration and Questions  

Page 2 / 2
  RSS
SubseaUK
(@subseauk)
Eminent Member
RE: First Layer Calibration and Questions

Hi Joan,  Well I went and tried the calibration square, and although I never did the wizard again or made any Z offset adjustments, it looked at first glance not to bad. However on closer inspection it was clear to see that I was far to high as there was no cohesion between the lines which would seem to indicate a lack of  "squish" so I will be running again today and adjusting the Z offset to close the gap between the nozzle and the bed.

I have attached a couple of photos to show what happened on the first run

On a slightly different issue, once the best Z offset has been reached does this get automatically stored within the printer or is there something else needed to be done to achieve this. I am concerned that if the printer gets powered down that the Z offset will change again.  Also if I use another sheet ( from smooth to textured ) does the new Z get stored under the sheet title?

Thanks for all your help and patience.

Kev

 

 

Publié : 06/04/2022 10:05 am
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: First Layer Calibration and Questions

 Live Z does indeed get stored, and should be available for your next print. 
regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Publié : 06/04/2022 7:39 pm
Page 2 / 2
Partager :