Notifications
Clear all
Finished assembly feedback...
1)Got the Y axis backwards.
Had to disassemble and fix when heatbed would not mount.
So a more specific warning that Y axis has a left/right would be helpful.
2)Wireing,It would be way easier to do final wiring if the door /electronics opened to the outside, rather than the inside of the printer.
IE turn the electronics mount/door around 180 degrees so one had clean access from the outside.
3)The warning about breaking the magnet needs to be larger and in big print, thank you for providing a spare set of magnets.
Very nice manual, very clear instructions, I enjoyed building the printer.
Posted : 07/02/2021 11:16 pm
RE: Finished assembly feedback...
You should send this by email to Prusa. I am sure they do not get a lot of positive feedback.
--------------------
Chuck H
3D Printer Review Blog
Posted : 08/02/2021 10:35 am