Cannot print - printer retracts filament on start
When starting to print,
the printer does the dummy extrusion line in the non printable place of the board,
however, after that, it retracts a LOT of filament back and when doing
the first layer, there is no material to extrude.
I did not alter any software/driver.
The GCODE before printing looks like this
;FLAVOR:Marlin
;TIME:356
;Filament used: 0.231121m
;Layer height: 0.15
;Generated with Cura_SteamEngine 3.6.0
M82 ;absolute extrusion mode
G21 ; set units to millimeters
G90 ; use absolute positioning
M82 ; absolute extrusion mode
M104 S200 ; set extruder temp
M140 S60 ; set bed temp
M190 S60 ; wait for bed temp
M109 S200 ; wait for extruder temp
G28 W ; home all without mesh bed level
G80 ; mesh bed leveling
G92 E0.0 ; reset extruder distance position
G1 Y-3.0 F1000.0 ; go outside print area
G1 X60.0 E150 F1000.0 ; intro line
G1 X100.0 E25.5 F1000.0 ; intro line
G92 E0.0 ; reset extruder distance position
G92 E0
G1 F2100 E-0.2
;LAYER_COUNT:67
;LAYER:0
M107