Notifications
Clear all
bumps
can anyone help me out and tell me how to correct this issue that happened after i upgraded to the new firmware.
I have adjusted retraction to 1mm, retract on layer change is enabled as well as wipe while retracting (slic3r PE).
Posted : 19/12/2018 10:58 pm
Re: bumps
normal. use the align seam option if you want to try and hide them better.
tuning your K value can also help.
Posted : 20/12/2018 12:01 am
Re: bumps
I have also the same problem.
Do you had checked if downgrading firmware will help?
Which version of the firmware do you have?
Posted : 09/01/2019 5:14 pm
Re: bumps
It is the layer change seam. It's normal. Check your model in Slic3r, it will also show their location so you can try to make them less prominent.
Posted : 10/01/2019 3:30 am