Notifiche
Cancella tutti
3 months later somethings wrong with the z axis
i bought the MK3s assembled and worked really well for several months. I haven't printed anything in a few months and it was doing fine when i last printed. Now coming back to it something is very wrong. its as if the z axis doesnt know where to stop. it goes to the top and clicks roughly for a few sec when attempting to calibrate, then moves down and grinds into the build plate. ive tried multiple self tests and calibrations. what could be going on?
Questa discussione è stata modificata 4 years fa da Mosler
Postato : 07/03/2021 1:48 am
RE: 3 months later somethings wrong with the z axis
Is the pinda sensor working, it should see the steel plate.
After not using a printer, I would clean rods and put oil on rods, move rods over the whole length, and then try to print.
A z-calibration should be enough, and then try to print.
Postato : 07/03/2021 7:54 pm
Topic starter
answered:
RE: 3 months later somethings wrong with the z axis
turns out something got jacked in my slicer settings.
Postato : 08/03/2021 9:58 pm