Notifiche
Cancella tutti
Extruder fan running at max speed all the time
Hello
I recently replaced my heater cartrige and thermistor, after i did that the fan is running on max speed all the time when i start a new print.
This means i can only reach about 217 degrees and thus can start any PET-prints.
I get no error message at all. Do anyone here know what the error could be?
Regards
David
Postato : 11/09/2023 9:14 am
RE: Extruder fan running at max speed all the time
Which fan are you talking about?
Fan 1 always runs at maximum and is independent of the set temperature.
Whether Fan 2 runs depends on the filament used and can have variable speeds during printing.
Postato : 12/09/2023 1:11 pm