Autoloaad not working all the time since firmware upgrade.

Ultimi post

RSS

Rusty Jones

(@rusty-jones)

Eminent Member

Autoloaad not working all the time since firmware upgrade.

So after upgrading to the latest firmware for the MK3S+ filament autoloading has been spotty at best. Maybe less than 10% of the time. I have been just advancing the extruded to get filament loaded. Now I also changed the nozzle at the same time. Where would I start trouble shooting this?

Thanks

Rusty

Postato : 28/08/2023 11:06 pm

PGe-10

(@pge-10)

Active Member

RE: Autoloaad not working all the time since firmware upgrade.

I am experiencing the same problem, put FW 3.13.1 on one of my MK3s+ and after this installation Autoload has stopped working

Postato : 06/09/2023 12:58 pm

Statistiche Forum

559 Forum

62.4 K Discussioni

440.4 K Post

19 Online

67.9 K Utenti

Post recenti: HF Nozzle Ultimo utente registrato: Kyle Cornelius Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso