Autoloaad not working all the time since firmware upgrade.
 
Notifications
Clear all

Autoloaad not working all the time since firmware upgrade.  

  RSS
Rusty Jones
(@rusty-jones)
Eminent Member
Autoloaad not working all the time since firmware upgrade.

So after upgrading to the latest firmware for the MK3S+ filament autoloading has been spotty at best. Maybe less than 10% of the time. I have been just advancing the extruded to get filament loaded. Now I also changed the nozzle at the same time. Where would I start trouble shooting this?

 

Thanks

Rusty

Posted : 28/08/2023 11:06 pm
PGe-10
(@pge-10)
Active Member
RE: Autoloaad not working all the time since firmware upgrade.

I am experiencing the same problem, put FW 3.13.1 on one of my MK3s+ and after this installation Autoload has stopped working

Posted : 06/09/2023 12:58 pm
Share: