Notifications
Clear all

Warping with PLA  

  RSS
Pengouin
(@pengouin)
New Member
Warping with PLA

Hello,

I'm a proud owner of a MK2 printer. I'm very happy but I have a warping problem. Most of the time it's not an issue but today I lost 600 gr of filament because 2 parts can't join themselves.

I use Slic3r Prusa Edition with default 0.2 mm PLA profile. My filament is PLA from Prusa shop. My model have brim (it's build in so I'm not using Slic3r brim). I clean my bed with 99.9 IPA before each print. I have try to lower my Z-level but I think I'm already at the limit (I have already a small elephant's foot effect)

It always start ok but after 3 or 4 hours it's begin to warp (including the brim if any). At the end I have a gap of 1 or maybe 2 mm all around the model. If the model print fast enough (no more than 3 hours) it's not warping.

Can you please help me find a solution ?

Thanks

Publié : 10/12/2016 7:06 pm
Nick
 Nick
(@nick-19)
Trusted Member
Re: Warping with PLA

I had a similar issue, after the first layer I turned up the bed temp to a max of 65(don't turn it any higher as PLA won't like it) and I turned the HotEnd down to 208(for Prusa Filament). Stopped all my issues with the corners coming off.

Hope this helps

Publié : 10/12/2016 8:02 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
Re: Warping with PLA

Hi Nicholas,
that sounds like a large model.
what bed temperature are you using?

I generally use 60degrees C and 65 for larger models...

this may help you
regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Publié : 10/12/2016 9:28 pm
Joseph Casha
(@joseph-casha)
New Member
Re: Warping with PLA

I'm Having the same exact issue

same PLA as well, whether it's a large print or a small print. Starts out fine, but after a certain amount of time it starts warping along the edges. i haven't had this issue with any other PLA. For the last 5 or 6 prints i only used prusa PLA so will try again with a different PLA to test, maybe i changed something in the settings which affected it

Publié : 12/12/2016 11:19 am
Pengouin
(@pengouin)
New Member
Topic starter answered:
Re: Warping with PLA

I have try to set the bed to 65 for my last big print and it went fine. I currently try a second one with same settings.

Thanks for your help 😉

Publié : 12/12/2016 12:03 pm
Partager :