Notifications
Clear all

Two Qestions  

  RSS
christopher.d3
(@christopher-d3)
Estimable Member
Two Qestions

1) What material is used for the i3 MK2 printable parts?
2) What connectors are used on the heater wires?

Posted : 22/02/2017 8:20 pm
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Two Qestions

1. ABS and PETG
2. Molex: http://shop.prusa3d.com/en/mk2-spare-parts/125-rambo-mini-heatbed-connector.html

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 22/02/2017 9:22 pm
christopher.d3
(@christopher-d3)
Estimable Member
Topic starter answered:
Re: Two Qestions

Great. Thanks, Peter.

Posted : 22/02/2017 10:19 pm
christopher.d3
(@christopher-d3)
Estimable Member
Topic starter answered:
Re: Two Qestions

One problem - I am not permitted to view that page. 🙁

Posted : 23/02/2017 12:52 am
christopher.d3
(@christopher-d3)
Estimable Member
Topic starter answered:
Re: Two Qestions

I guess I should have looked before posting. I didn't realize the various heater wires feed into pluggable terminal blocks, not permanently connected connectors. So, swapping the terminals should be easy and solves my problem. But I ordered a few from UltiMachine anyway. (They make the RAMBo mini board with the corresponding sockets and sell the terminal blocks as auxiliary parts.)

Posted : 23/02/2017 6:16 pm
Share: