Replaced mini RAMBO and now can't calibrate
 
Notifiche
Cancella tutti

Replaced mini RAMBO and now can't calibrate  

  RSS
Eli
 Eli
(@eli-4)
Active Member
Replaced mini RAMBO and now can't calibrate

I had to replace my mini rambo. Flashed with 3.0.9 and now it's like the calibration routine is shifted over from where the points actually are. I've verified that the pinda picks up each point but during the routine it's sweep ends before it gets to the point. Is there an X calibration somewhere I'm missing? I'm doing auto-home then xyz calibration.

Postato : 02/01/2017 3:06 am
Ancientwolf
(@ancientwolf)
Estimable Member
Re: Replaced mini RAMBO and now can't calibrate

Rambo from Prusa?

Yeah, its that guy... 3D Nexus

Postato : 02/01/2017 5:01 am
Eli
 Eli
(@eli-4)
Active Member
Topic starter answered:
Re: Replaced mini RAMBO and now can't calibrate

No, I was being impatient and used one of these: https://ultimachine.com/collections/electronics/products/refurbished-mini-rambo-1-3

didn't figure there would be much difference once I loaded the firmware.

Postato : 02/01/2017 6:40 am
Condividi: