Notifications
Clear all
Replaced mini RAMBO and now can't calibrate
I had to replace my mini rambo. Flashed with 3.0.9 and now it's like the calibration routine is shifted over from where the points actually are. I've verified that the pinda picks up each point but during the routine it's sweep ends before it gets to the point. Is there an X calibration somewhere I'm missing? I'm doing auto-home then xyz calibration.
Publié : 02/01/2017 3:06 am
Publié : 02/01/2017 5:01 am
Topic starter
answered:
Re: Replaced mini RAMBO and now can't calibrate
No, I was being impatient and used one of these: https://ultimachine.com/collections/electronics/products/refurbished-mini-rambo-1-3
didn't figure there would be much difference once I loaded the firmware.
Publié : 02/01/2017 6:40 am