Post your test/benchmark prints here!
I figure a place to post our 3dbenchy's and treefrogs might be helpful.
Here's my first benchy with the kit:
Re: Post your test/benchmark prints here!
I did a benchy as well 🙂
Re: Post your test/benchmark prints here!
I figure a place to post our 3dbenchy's and treefrogs might be helpful.
Here's my first benchy with the kit:
http://imgur.com/gallery/cuuMv/new
That's great. I'd like to know how you were able to take such a good photo, what's the key? Lighting? Camera?
Re: Post your test/benchmark prints here!
here's a pretty good print off the whistle. I'm still having issues with bed adhesion and first layer stringing, but this printed nicely.
Re: Post your test/benchmark prints here!
Niels
Bed adhesion - increase bed temp to 55 or 60 degrees and ensure that the first layer height is >= 0.2mm. Use an enlarged brim and/or raft.
Stringing: If on first layer, then it's usually due to pressure in the nozzle following initial prime line, other layers then reduce extrusion temp by 5 or 10 degrees.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: Post your test/benchmark prints here!
Here is my first benchy print. Something is a bit off with the smoke stack.
