NinjaFlex this stuff sticks!
Just a word of caution for any one printing flex filaments. I would recommend using glue stick to avoid over adhesion. My bed was getting a bit scratched up so it needed replacement, but wow this stuff sticks. I did manage to get my print setting perfect for NinjaFlex. Now I just need to get this fixed so I can get printing again.
Re: NinjaFlex this stuff sticks!
I think its in the manual somewhere that you should use glue for flexible filaments.
Although as you, I learned the hard way (not THAT hard though), my first prints was sooo stuck, I couldn't believe it. Started to do some in deep testing, and now I'm printing first layer pretty high, about 0.1-0.15 higher than PLA. And always use glue.
Re: NinjaFlex this stuff sticks!
I have used a film of Talcum powder and wiped off the surplus, for flex and PETG, with some success.
regards joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK