[Chiuso] New heated bed on MK2S

Ultimi post

RSS

Robert Gabel

(@robert-gabel)

New Member

New heated bed on MK2S

Anyone know if it is possible to just upgrade the MK2S with the new spring steel bed without the rest of the upgrades? I tend to print large flat objects and getting them off the bed is often a challenge as I do not want to damage the PEI coating.

Postato : 18/01/2018 10:52 pm

antoine.m2

(@antoine-m2)

Active Member

RE: New heated bed on MK2S

Hi!

I would like to do the same!
Did you do it? Or did you get an answer of your question?

Postato : 16/04/2020 6:39 pm

Statistiche Forum

566 Forum

63.2 K Discussioni

444.3 K Post

21 Online

68.1 K Utenti

Post recenti: M112 error when sending gcode from Octoprint to MK3.5S but prints fine from USB stick Ultimo utente registrato: etiennep Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso