Many issues with my printer (2 weeks of printing/ testing)
I'm just wondering if these issues are normal for this printer.
X axis delta drive motor pulley wobbles
Bed temperature 15 to 20 degrees lower on the front right edge.
Pei sheet bubbling and no longer stuck to the bed in some areas.
Pinda probe no longer working an hotend crashes in bed ( wire defective ). I had to splice in another section of wire to get it running.
Print quality is not so good compared to my other printers ( vertical lines and some ringing on prints ).
If this is the best printer ( my reference is several YouTube videos ) I'd hate to see the worst.
Maybe just got a lemon.
My other printers are Cubicon Single , Wanhao D6 , Wanhao i3 v2, Raise3D F1, Micromake Delta
Re: Many issues with my printer (2 weeks of printing/ testing)
Kit or Factory Built?
Yeah, its that guy... 3D Nexus
Re: Many issues with my printer (2 weeks of printing/ testing)
It is a kit.
Re: Many issues with my printer (2 weeks of printing/ testing)
If possible could you run some of the test prints and post the photos to this thread?