Linear rods not seated, printing fine?  

Linear rods not seated, printing fine?

So, I don't know if this is another black PETG part issue, a lot of them seemed to be suffering from some slight part shrinkage or something, or if I just screwed up in the installation. If you look at the comments on the online manual, you'll see a lot of us having struggles with the black printed parts being just a tad tighter it would seem, than the orange ABS parts. So, I was pulling a bunch of prints off my print bed this morning, when I leaned on the bed slightly. Much to my surprise, it stayed down. It would appear I installed all of the rods sitting on top of all of the nests for them. My print quality is off the charts, so I hate to mess with it. Anyone else seen this, and seen it not affect print quality? I really don't feel like tearing it down to fix this, and having to get my Z dialed in perfectly again like I have it.