Notifiche
Cancella tutti
Increase Motor Current
I upgraded my Prusa i3MK2S to a titan extruder a while ago. Part of the install instructions were to increase motor current for extruder motor to give it a little more juice using M907 X640 Z830 E800 ; set Titan Extruder Current. I did this in the firmware a while ago but looking it up further, it doesn't look likes this is supported in Marlin firmware.
Is there an alternative method for the MK2S?
Thanks!
Postato : 25/08/2017 9:00 pm
Topic starter
answered:
Re: Increase Motor Current
Nevermind....Was looking at wrong code on cheat sheet lol...
Either way, anyone have any other tips for titan extruder? Used this version https://www.thingiverse.com/thing:2065461
Postato : 25/08/2017 9:03 pm