Bed adhesion trouble. Please help.
 
Notifications
Clear all

Bed adhesion trouble. Please help.  

Strona 3 / 3
  RSS
Klaus
(@klaus-2)
Eminent Member
Topic starter answered:
Re: Bed adhesion trouble. Please help.

JohnOFII:

Been using your Raptor PLA normal 0.2 S3D settings with very nice results. Question: Did you modify only the 0.2 PLA setting, or other qualities as well? What about the ABS settings?

Best regards,
Klaus - Norway.

Opublikowany : 27/11/2016 7:03 pm
Klaus
(@klaus-2)
Eminent Member
Topic starter answered:
Re: Bed adhesion trouble. Please help.



I'm from norway too, and I bought IPA at kjell.com
https://www.kjell.com/no/produkter/hjem-kontor-fritid/kontorstilbehor/kjemi-spray-lim/spray-olje-isopropanol/luxorparts-ipaclean-isopropanol-1000-ml-p18356

99.5% should be good enough 😉

Nice! I live in Tønsberg, so not exactly near a shop, but I travel to sweden to shop quite a bit, and there is a Kjell&Co in Nordbysenteret.. 🙂

I have been buying PLA filament at 3Dbergen.. They are shutting down, and are selling out their stock of filament at reduced prices on finn.no.
good quality stuff.

Best regards,
Klaus - Norway.

Opublikowany : 27/11/2016 7:07 pm
Kgamer
(@kgamer)
New Member
Re: Bed adhesion trouble. Please help.

Hello!!!! I have the same problem like you in November 2016 with the pei adhesion. You said that"I sanded the PEI sheet with 2000 grit sandpaper (yeah.. that is ULTRA fine grade..)" have corrected the problem... Please can you send me an image of it and features, i am in togo in West Africa and cannot buy on amazon, they not delivered in my region.... But perhaps i can find it on Alibaba.... Thanks for helping me

Opublikowany : 19/11/2017 12:17 am
Strona 3 / 3
Share: